• Atomium Active Diesel Plus

Lubricant Atomium Active Diesel Plus is designed for treatment of diesel engines of passenger vehicles and light trucks with mileage more than 50 000 km


FEATURES

Treatment stages

Oil volume in the oil pan

From 2 to 7 ltrs

From 7 to 10 ltrs

1st stage

1 can

2 cans

2nd stage

1 can

2 cans

3rd stage

1 can

2 cans

Treatment scheme by stages

1 + 1 + 1

2 + 2 + 2

 

Precautions: Not harmful if applied correctly.

First aid:

  • In case of a contact with skin remove the material wash out with warm water, and then wash again with soap
  • In case of contact with eyes wash out eyes with large amount of water
  • In case of swallowing consult a doctor

APPLICATION MODE

The 1st stage: Add Lubricant Composition Atomium Active Diesel Plus to the engine oil 500-1000 km before oil replacement, pour through the oil filling neck (see the graph for calculation), then run the car till the next regular oil replacement (but no less than 500 km). In case of a significant oil contamination (identify by the color of the oil on the dipstick or oil spots on filter paper) start the second stage of treatment immediately.

Recommendations (after the 1st Stage): Change oil. Replace oil and air filter.

The 2nd stage: Add Atomium Active Diesel Plus to the new engine oil (see the graph), and then run the car in a regular mode till the next oil replacement.

The 3rd stage: Add Atomium Active Diesel Plus to the new engine oil (see the graph), and then run the car in a regular mode till the next oil replacement.

Important:

  • Before applying Atomium Active Diesel Plus shake the can thoroughly until natural sediments (active components) are totally dissolved.
  • Apply Atomium Active Diesel Plus through the regular oil filling neck of the warmed-up engine
  • After applying Atomium Active Diesel Plus the engine should work on single turns (at idle) for 5 min. and then run for no less than 20 min. in any mode (regular operation)
  • It is not recommended to apply the lubricant at existence of mechanical breakages of parts and assemblies
  • Atomium Active Diesel Plus is compatible to any type of engine oils and doesn't change their properties
  • For providing continuous level of engine protection it is recommended to apply Atomium Regular 30 000 - 40 000 km after complete treatment with Atomium Active Diesel Plus
  • After 100 000 km complete  re- treatment is recommended
  • For turbocharged engines and forced engines the re-treatment is recommended after 50 000 - 55 000 km
  • To achieve the full level of protection the treatment of all vehicle parts is recommended, such as transmission gears, hydraulic power steering etc.

EFFECTS OF APPLICATION

  • Cleans friction surfaces from lacquers and deposits on the 1st stage of treatment, including de-coking of the piston rings in their mobility
  • Increases and stabilizes compression in the ICE cylinders (due to the formation of a new layer and sealing gaps in friction units)
  • Restores oil pressure in the engine oil system up to rated
  • Decreases oil waste
  • Increases of the engine life in 1.5 - 2 times (due to wear intensity decreasing)
  • Increases engine effective power (as a result of fuel combustion quality improvement, decreasing combustion gas leakages to carter, and drop of friction losses)
  • Reduces oil waste consumption in the engine up to 3 times (due to the increase in gas-tight piston grooves)
  • Provides maximum engine protection in extreme working conditions, also in case of overloading or overheating and during «cold start-up»
  • Makes start at low temperatures much easier
  • Does not degrade operational characteristics of rubber parts
  • Decreases fuel consumption of internal combustion engine to 8 - 10 % (as a result of compression recovering and combustion quality improvement)
  • Significantly  decreases noise and vibration levels (by 5 - 10 dB of the diesel engine (due to forming of thick and resistant lubrication “pillow” and clearances optimization)
  • Decreases exhaust CO/CH emissions up to 50 % (as a result of improvement of combustion quality)
  • Provides possibility of short-time run under oil starvation conditions or when oil (oil pressure) is completely lost
  • Restores the work of hydro-compensators (tappets)

Write a review

Note: HTML is not translated!
    Bad           Good

Atomium Active Diesel Plus

  • Product Code: Engine
  • Availability: In Stock
  • AU$48.00

  • Ex Tax: AU$48.00

Related Products

Atomium AGSB 80

Atomium AGSB 80

Designed for application on automatic gear boxes, variators of any type and mechanical gears that use transmission oil Dexron ATF (red oil). The treat..

AU$46.00 Ex Tax: AU$46.00

Atomium MGSB 100

Atomium MGSB 100

Designed for applying on mechanical gear boxes, rear axles, reduction gears of any type and self-locking differentials. The treatment to be made in on..

AU$36.00 Ex Tax: AU$36.00

Atomium HPFP 100

Atomium HPFP 100

Designed for application on High pressure fuel pumps (HPFP), Common rail systems, Pump injectors of diesel engines with the working volume no less tha..

AU$36.00 Ex Tax: AU$36.00

Atomium HPS 60

Atomium HPS 60

Designed for application on hydraulic power steering of any car that uses transmission oil Dexron ATF (red oil).FEATURESLubricant Composition Atomium ..

AU$34.00 Ex Tax: AU$34.00

Atomium Active Regular

Atomium Active Regular

The compound is designed to protect against wear and maintain the performance of diesel, gasoline and gas engines of passenger vehicles, pretrea..

AU$25.00 Ex Tax: AU$25.00

Atomium Reducer 80

Atomium Reducer 80

Tribotechnical compound «Reducer» is designed to protect against wear, increase the lifetime and restore characteristics of transfer boxes, limited sl..

AU$29.00 Ex Tax: AU$29.00